Tuesday, October 18, 2011

Pullover Towel Baby Bib Tutorial

As I was mass producing baby bibs I decided to snaps some shots for  a little tutorial.  Not that there is any shortage of baby bib tutorials out there, but they are all just a little different.  So here's my take on the Pullover Towel Baby Bib.  Thank you for teaching me how to make these mom!!


I had a lot of left over towel pieces from making Hooded Baby towels.  These bibs can also be made from small hand towels also sometimes called fingertip towels, which are already finished on the edges so you don't need to bind them.

Let's get started. For 1 bib you'll need:
  • Towel fabric-  11" X 15"
  • Knit ribbing-  2 1/2 " X 11"
  • about 2 yards of double fold binding (there will be leftover)
  • applique fabric and fusible web for front as desired
  • coordinating thread, of course.

Use a cup to trace a curve on the corners of the towel.  For the neck hole use a 5 inch diameter circle and position the circle in the center,  1.5 inches down from the top of the bib.  Trace the circle and then cut on all tracing lines.



Next, apply the bias tape around the edges.  I don't have the energy to go into all the details about bias tape. Thankfully Dana from Made has done such a great job of describing this that I'm going to refer you to her tutorial on sewing on bias tape.  I use the cheating method. :)



See!


Next take the ribbing, fold it in half, and sew the short edges together.


Then fold it in half lengthways so the seam is on the inside, with the seam finger pressed open.


Next, Pin the ribbing to the towel.  To do this, first divide the ribbing in 4 equal sections and mark them with pins or a marking pen.  Then divide and mark the neck hole in for equal sections.  Match up the markings and pin them with raw edges together.  Stretch the ribbing to meet the neck hole and pin as needed.   You should get something like this.


Now using a serger, or stretch stitch on a regular machine,  sew the ribbing onto the neck hole.  Stretch the ribbing as you go to match up the raw edges.  If using a regular machine, zig zag stitch around your raw edges to minimize fraying.


The front side should look something like this.



Next, use fusible web to apply your desired fabric and zig zag around the edges.


And there you have your bib!


If you use this tutorial to make a bib please link back or leave me a comment to let me know that you did.  I'd love to see what you made!! 

Happy Sewing!

4 comments:

  1. very cute! what age would you say this fits? i'm concerned about my kids' mega heads not fitting through the hole because the terry won't stretch! :) lisa

    ReplyDelete
  2. That's a good question. I made them for my kids when they started solids and they used them all the way till they were 3 years old. My kids have big heads too compared to other kids. The opening is a circle which means it will stretch on the bias sides of it. The trick to allowing it to fit over their heads is making sure you don't get the ribbing too tight. After you cut the knit ribbing and sew it together to form a circle, Try it on over your child's head to make sure it goes on nicely. You can also put the terry cloth hole over their head before you sew it if you are worried, just to make sure it goes over easily as well. Good Luck and let me know how it goes.

    ReplyDelete
  3. I love this tutorial, and can't wait to make some!!! Thank you!

    ReplyDelete